3D model of francfalco
The models were repaired and checked for printability.
I was asked by the kitchen at my company to create a new table sign for our
...Plus restaurant - the old one's were made from paper and beginning to look a bit 'dog-eared'.
So i designed and printed these.
The area under 'Reserved' has our company name embossed into the model, but if you haven't access to 3d software then just write onto the panel to customise the signs.
Printed face down as the .stl is set up
No raft or supports needed.
Enjoy!
http://twitter.com/francfalco
