3D model of francfalco
The models were repaired and checked for printability.
I had to raise my printer up from the desk surface to allow a larger filament spool
...Plus to fit behind - i did have it standing on some old books, but not a great look!
So, I created this stand.
No support or raft needed.
Print at low res.
The .stl file attached elevates the printer 100mm (approx) from the desk. However, the stand height is easily adjusted in any 3d software.
Print x 4 and you'll need to replace the existing lower corner hex head bolts with 5mm longer thread versions to secure the stands to the printer.
Enjoy!
http://twitter.com/francfalco
