3D model of gamescape3d
The models were repaired and checked for printability.
Back after short RL Hiatus, I finished this late last month
52 mm Minotaur stands
...Plus about 70mm. Lightly Inspired by KOBL Minotaur. I highly suggest HIPS printing for my figures on FFF machines however this fella should be large enough to manage without. I also suggest dialing down the speed for HIPS printing, see below
This model is designed for HIPS printing.
ASSEMBLY REQUIRED:Will likely require xacto blade, or sanding, and superglue to assemble weapons/shields to figure. We advise the following settings for slicing
Layer height: Between .2mm
auto_support: Between 1- 1.5mm or 40-50% HIPS fill
Fill Density: 15% or greater
3 shells
Print speed
30 outlines
75 fill
Other notes
glass plate with HIPS slurry allows for plate to heat only to 100c without issue.
Printer brand:
MakerBot
Printer:
MakerBot Replicator
Rafts:
Yes
Supports:
Yes
Resolution:
350000 poly
Infill:
15%
Notes:
Dissolvable filament print.
Acetone brushed flesh areas, acrylic paint
http://twitter.com/GameScape3D
