3D model of skimbal
The models were repaired and checked for printability.
Vrroormmmm.... VVVVRRRROOOmmmmm. VVVVRRROOOMMM! VVVVRRROOOMMM
...Plus VVVRRROOOMMM!
Instructions
1)Print out segments to make a chainsaw of your desired length. (Each segment is 10cm.)
2)Attached segments together.
3)Add Tip to one end.
4)Add end to other end.
5)Bolt finished chainsaw blade to 1 gallon plastic gas can.
6)Cut a hole in the back of the gas can and stick your hand inside.
7)Wave it around shouting at the top of your lungs... Vroommm... VRROOMMM... VVVRRROOOMMMMMMMM!
A special thanks to Annelise Jeske and Tony Sherwood for helping with the pictures!
https://twitter.com/KCKITCO
