3D model of iczfirz
The models were repaired and checked for printability.
Yet another easy printable and usable Goggles. [Optimised for 3D Print on Transparent
...Plus Film].
Goggles weight 29gram (Stripe inclusive).
Why not Goggles made from PLA?! It is brittle. Please google more about PLA before you start to print and/or design.
It is just TOO DANGEROUS to put on your face, it is too brittle. If a PLA mask cracks, it will cut your face and eyes like a knife.
A fatal scenario could be something may strike your PLA mask like poor Kevin
Files explain.
Why Goggles_Top_Aligned? It give the best 3D print result as there is no nozzle travel at all. So zero Oozing. The trade off is you need more time and tpu per print. (39g vs 22g. 2h14m vs 1h25m.). And you need to trim it by a pair of scissors.
Setup new Cura Profile
Material
-Generic TPU 95A (reminder. Cura default extruder setup is 2.86mm. You may need to set it to 1.75mm.)
Print Settings (Setup new Profile base on stock Extra Fast 0.3mm base profile)
-Custom
Profile
-Extra Fast -0.3mm
Layer Height
-0.3mm
Initial Layer Height
-0.2mm
Wall Thickness
-1.2mm
Fill Gaps Between Walls
-Nowhere
Seam Corner Preference
-None
Infill Density
-100%
Build Plate Temperature
-20degC
Build Plate Temperature Initial Layer
-50degC
Layer Start X
-0 (delta), or
-Max X size / 2 (Rectangle bed. Lower Left as origin)
Layer Start Y
-0 (delta), or
-Max Y size / 2 (Rectangle bed. Lower Left as origin)
Skirt Line Count
-3
**Fine tune retraction (I use 5mm) speed (I use 60mm/s) and extra prime (I use 0mm) for your extruder and TPU.
https://www.instagram.com/iczfirz/
