3D model of turbo_sunshine
The models were repaired and checked for printability.
I decided to make make a fully 3d printable brush design that can be adapted by
...Plus future designs.
In this first batch of brushes I will release a Bouldering/Climbing Brush, a Nail Brush, and a small Test Brush.
The brushes print in about 4 hours, (test brush around 30 min).
Use a 0.4 mm nozzle(and 0.4 mm line width), and 0.2mm layer height.
ConfusedPrinter Found that when printing with PETG, one has to use the cooling fan to get reliable bridging. - More testing needs to be done to find the perfect fan speed, however at 100% fan speed the print definitive succeeds!
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Notes:
0.4mm Nozle
0.4mm Line Width
https://www.instagram.com/sunshine_turbo
