3D model of nakozen. The models were repaired and checked for printability.
Strike fear among the Rebel starfighters with the TIE Advanced X1, most notably piloted
...Plus by Darth Vader during the Battle of Yavin! An experimental variant of the mass produced TIE fighter used heavily by the Galactic Empire, it hosts an impressive array of advanced technology and weaponry, though due to its high costs was later replaced by the exceptionally deadly TIE Interceptor.
It has taken me a while to redesign the clips to the point I was completely satisfied with them, alongside the experimental folding panels. Take caution not to flex panels too much in the opposite direction! Results may vary, some may require glue or a little filing, but as always I design my kits with the intention of being snap fit straight off the printer! This is the way.
Included is the standard kit, along with a halved variant for smaller print beds, and another without the frame for those uninterested in the kit format. Individual parts files also available as per usual.
Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament brand:
Geeetech
Filament color:
White
Filament material:
PLA
Notes:
It's a nice snap fit for me and my printer, results may vary! To tweak the tightness, simply increase or decrease the Z height in your slicer, otherwise a little glue can go a long way!
No tools required, however I would recommend some wire snippers and a small blade for clean-up :)
Nakozen3D@gmail.com
