3D model of uwcharlie1983. The models were repaired and checked for printability.
This a weighted poker card capper. It is placed on your hole cards during a hand
...Plus to make sure they are not accidentally folded. The base is designed with the same diameter (39mm) as a standard size poker chip so this will stack perfectly on your chips when not in use.
This design is the Dallas Cowboys logo.
--- Printing ---
1) Print two of the silver stars.
2) Print one each of the other parts.
3) The main blue star is not symmetric; make sure to print with the deeper star cutout down. This will allow the surface that has the support material removed to be covered up with the thin blue star.
4) I printed the holder (upside down) and base with line support material spaced at 4.5mm.
--- Assembly ---
1) The holder is designed to have 4 nickels placed inside of it as ballast prior to it being snapped into the base.
2) Remove support material from main blue star and glue thin blue star into main blue star to cover surface that had support material removed.
3) Snap a silver star into each side of the blue star. A few drops of glue could help hold them in place.
4) Slide the assembled star into the two triangles on the top of the base. A few drops of glue would be beneficial to keep it together.
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
10%
Notes:
Supports are only necessary on the main blue star, base and holder.
