3D model of uwcharlie1983. The models were repaired and checked for printability.
This a weighted poker card capper. It is placed on your hole cards during a hand
...Plus to make sure they are not accidentally folded. The base is designed with the same diameter (39mm) as a standard size poker chip so this will stack perfectly on your chips when not in use.
This design is of an octopus wearing a top hat.
1) Print the Cute Octopus at 42%
2) Print the Top Hat at 52%
3) Print the Base & Holder at 100%
4) I printed the holder (upside down) and base with line support material spaced at 4.5mm.
--- Assembly ---
1) The holder is designed to have 4 nickels placed inside of it as ballast prior to assembly.
2) With the nickels inside the holders snap the base over the top of it.
3) Super glue the Cute Octopus to the base and then Top Hat to the Cute Octopus.
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
Yes
Resolution:
0.1 mm
Infill:
20%
Notes:
Make sure you scale the models as noted in the summary.
