3D model of PRIma. The models were repaired and checked for printability.
3 Jaw Chuck modified for the Desk Clamp Version of my recently published Nano Vise
...Plus V2
Easily swap between Vise or Chuck for your work!
Suitable for any round shaped parts like figures with bases for tabletop gaming or any other general woodwork/hobby.
Max. clamping diameter 75mm (Jaws reverse mounted)
following parts has been modified
Housing:
removed holes on the outer diameter (task tighten/untighten by hand)
Small size corrections and designed possibility to use M8 screw to mount it onto the ball-joint for the C-clamp.
Scroll-Plate:
removed holes on the outer diameter (task tighten/untighten by hand)
designed "grippy" grooves on the outer diameter for tighten/untighten the parts by hand
Thicken the height for more area to grab by hand
Assembly Jaws into the Scroll-Plate:
Start with Jaw A slide into the begin of the spiral (any of the 3 slot) and then rotate the scroll plate until the next slot where you place then Jaw B ...same for last Jaw C.
(simple: A/B/C reverse the Jaws : start with C/B/A)
You need M8x10 Allen Screw to mount the Chuck onto the Ball-Joint Shaft
Printer brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
30-40
Filament brand:
any
Filament color:
any
Filament material:
any
Notes:
support necessary only for Housing
You may need to sanding the jaws tooth before assembling into the scroll plate.
each jaw should move freely and easy in the scroll plate /spiral
https://www.youtube.com/channel/UCkWGgSjbHl0JN86glKJZuTA
