https://3dprint.nih.gov/discover/3dpx-013409
Model ID 3DPX-013409
Category Labware & Devices
Device Use Safety and Personal Protective Equipment
The
...Plus following refers to: 3DPX-013409
The FDA has authorized production of protective face shields outside of the normal clearance pathway during the COVID-19 pandemic, based on Part 5, section D of the “Enforcement Policy for Face Masks and Respirators During the Coronavirus Disease (COVID-19) Public Health Emergency Guidance for Industry and Food and Drug Administration Staff." This face shield has undergone review in a clinical setting and is recommended when fabricated as instructed.
A prototype face shield that Prusa Research developed. This is a version for the US based on the community feedback, the design was adjusted to fit:
- American size sheet (11x8,5 inches)
-American triple hole punch (distance 4 1/4", hole radius 1/4")
Also included is an optional elastic cover designed to close the gap in the headband, while keeping the entire headband flexible. The purpose of the cover is to further protect your face against the aerosol (e.g. cough) falling from the top.
PETG Recommended for all.
Model Origin
https://www.prusaprinters.org/prints/27950-prusa-protective-face-shield-rc3-us-version
WARNING! Ordering this 3D model printed you assume all risks associated with the use of the produced devices.
This 3D model has not been approved by any regulatory agency and has not passed any laboratory tests. We cannot guarantee its operation, so use it at your own risk.
