Hello folks
I was looking for a caged frame under 100mm for interior/exterior FPV and could not find one, so I designed my own.
This frame is designed for
...Plus 20x20mm FC and ESC mount and for 19/2035 propellers, this is a 96mm class frame with holes for 1103/1105 motors (Racerstar BR1103 and DYS BE1104 motors have been tested)
I build this frame around the parts I wanted so I recommend to check my part list:
- Piko BLX F3
- Cicada 4in1 10A or Multistar 4 in 1 10 A
- Eachine VTX03
- iPEX to SMA Mushroom Antenna
- 600TVL 120 Degree Camera
- FD800 Tiny Frsky 8CH PPM/SBUS Receiver
- DYS BE1104 6500kv Motors
- Lipo Tattu 450mah 75C, Tattu 650mah 75C and cheap Zop Power 500Mah 45C(I switched the plug to XT30)
You can use any 19/20 props, but I recommend the Furious FPV 2035-4 Propellers
It is compatible with the Eachine MiniCube and all 20x20 mounting FC and ESC.
You will need 14 M3 nylon spacers (20mm) + 28 M3 screws (6 to 8mm)
It should be very durable and lightweight depending on your filament type and quality. I would recommend using Nylon or Carbon fiber filament.
I will add mounts/adapters/parts soon (camera & VTX mount, landing pads...)
