I got my hands on the Pyro figure from notamusician, however it seemed to be direct from the game. I did some auto repairs and then split the figure up into four
...Plus sections. This removes a ton of supports that were needed for the tanks on his back. I then split the tanks in half so I could print them without supports as well.
As you will see in a pic I posted, I manually added a few extra supports for his feet and some in his hands. They came off easily and overall it printed a lot cleaner than expected.
The axe can be printed in one part but it needed supports to keep it up so I split it in half.
I printed the body at like 50% infill but that was just so it could be put up near a lit background without the honeycomb effect showing through. It could easily print at 10% even. I did 0.08mm layer height just for the detail.
This is my first time learning how to cut up models so if I did something wrong please tell me!!
