3D model of faberdasher
The models were repaired and checked for printability.
Game for a laugh? Our reindeer dress-up set will have everyone fawning over you. So
...Plus buck up and get ready to party!
Slice with 2 shells (/perimeters) and 2% infill. At coarse resolution (0.3mm), you will find prints have extra shimmer (and print quicker!).
Created in stunning Faberdashery Mercury Red PLA^ and Crystal Clear PLA^
Nose print requires ~11g of material (~2m of 3mm / ~4m of 1.75mm filament)
Antler print requires ~14g of material (~2m of 3mm / ~5m of 1.75mm filament)
The Antler print measures 203x148mm, so it will fit comfortably onto Ultimakers and the Replicator2 build plates. For smaller build plates this print will need to be scaled to fit.
Tie a length of elastic cord to the nose print and place over nose. Pop on the antlers and you're ready to party!
https://twitter.com/faberdasher
