3D model of bqeducacion
The models were repaired and checked for printability.
The PrintBot Beetle is an educational robot that can follow lines, search for light,
...Plus and grab objects with its claw.
The robot has been designed to attach other components such as servos, LEDs, push buttons, a buzzer, and other sensors included in the product "Zum Box" distributed by BQ.
BOM
Printed parts:
You will need to print one copy of each part, except for the following:
4 x screw_cover
2 x wheel_front
2 x wheel_rear
Hardware:
7 x M3x10 screw
1 x M3x12 screw
8 x M3x16 screw
2 x M3x25 screw
2 x M3x35 screw
14 x M3 nut
3 x M3 blocking nut
4 x 3x84mm O-ring
8 x AAA batteries
Parts included in "Zum Box" by BQ:
1 x Battery holder
1 x BQ Zum Core
2 x IR sensor
2 x Led
2 x Miniservo
2 x Continuous rotation servos
Build Instructions
See the attached pdf (in Spanish) in the "Files" section. Pictures are clear enough to follow the steps even if you do not understand Spanish.
Example code
Attached you will find two simple Arduino programs ("Arduino_escarabajo..."). One follows a line and the other searches for the brightest spot.
Android-Control
Now you can control your robot through the "RoboPad" app.
So just upload the "Arduino_robopad_escarabajo.ino" into your robot, connect the Bluetooth Module and install the Android app
Disclaimer
This thing and all other published material cannot be considered as a final product of bq and bq takes no responsibility of its use.
It must be considered as an experimental and early released product developed by the Innovation and Robotics Department staff with the intention to share it and test it as soon as possible within the community.
https://www.instagram.com/bq.educacion
